Ordos GRC light Partition board It is an ideal material to replace clay bricks in non bearing parts of buildings. In recent years, it has been widely used. It is also a new type of lightweight wall material, which is the key to the construction industry. Grc is the abbreviation of glass fiber reinforced cement. Since grc light partition board is installed in the non bearing part of the building, and the installation site is weak, attention should be paid to the connection of light partition board.

1. Grc lightweight partition board is connected to the plate in a straight line

Grc lightweight partition board is connected with the board in a straight line. The vertical side of the grc lightweight partition is an inverted splay. Apply glue and glue to the tongue and groove of the inverted splay tongue, and then sew up two plates. Apply glue on the joint surface first, and then reinforce it with glass fiber mesh.

2. Various connection modes of grc lightweight partition board and plate

The grc partition board and the panel can be connected in T-shaped, L-shaped and cross shaped ways. For T-shaped, L-shaped and cross connection between grc lightweight partition boards, first clean the connection position of the horizontal board, and apply glue and glue on the contact with the board edge. After gluing and splicing, glue and glue shall be applied on the joint surface, and glass fiber mesh shall be pasted on the surface for reinforcement.

3. Bottom surface of grc partition connecting beam

Connection of Grc lightweight partition with beam bottom and ceiling surface. The connection between Grc lightweight partition board and beam bottom and ceiling surface is fixed with cement and U-shaped anti vibration steel plate clamp. The U-shaped steel plate clamp is made of 60 mm long steel plate with a thickness of 2 mm and fixed with expansion bolts less than 4 mm. On the structural beam slab, glue and cement shall be applied to the inner corners of the light partition and beam slab, and the surface shall be reinforced with glass fiber mesh.

4. Connection between grc light partition board and wall

The connection between grc lightweight partition board and wall is mainly the connection between grc partition board and brick wall or block wall. It is fixed with glue and cement. Before connection, the brick wall or block wall shall be connected with glue. The contact points of grc light partition shall be evenly coated with glue, the inner corners shall be coated with glue and glue, and the surface shall be reinforced with glass fiber mesh.

*Disclaimer: The reprinted content is from the network. If you have any objection, please contact us in time, and the network will delete it.