Baotou GRC Component companies teach you how to install and fix components:
1) Line installation:
a. Section specification is less than 8mm × 8 mm φ eight × 100 Expansion bolts shall be directly punched on the red brick or concrete wall and welded and fixed with the embedded parts of the component (the welding points between the embedded parts and expansion bolts shall not be less than 4).
b. When the line section size is greater than 800mm × When it is 80mm, it is necessary to add angle steel support at cornice to fix it on the wall, and then use expansion bolts to weld embedded parts and component embedded parts on the wall. (except for component backfilling)
c. Special attention: when the wall is light cut φ 8 The reinforcement shall be welded and fixed with the embedded parts.
2) Install the window cover. Large expansion bolts or wall rods in the wall shall be welded with embedded parts. There shall be no less than 4 fixed points within 2000mm and no less than 6 fixed points beyond 2000mm.
3) Install floral and scroll components. The combined embedded parts shall be welded and fixed with the collision bolt or wall rod.
4) Install the trim panel, bottom plate, etc.
a. Half column through. 3 pieces must be used inside the column (Corinth type) φ 6. The reinforcement tie rod is fixed with the wall expansion bolt or wall bar.
b. Install the half column members.
*Disclaimer: The reprinted content is from the network. If you have any objection, please contact me in time, and I will delete it.
