Baotou EPS The decoration line mainly consists of adhesive, polystyrene line, crack resistant plaster mortar, alkali resistant glass fiber mesh, etc. All aspects have relevant requirements, and we can only operate according to the requirements. Then we can ensure that our products have good results. Requirements for its adhesive. Let's look at the following.
one EPS Basic treatment methods for component construction: degreasing, dust, loose materials, release agent and other substances that are not conducive to wall surface bonding.
2. Material preparation: add water according to 20-25% of the product weight, mix mechanically for 3 minutes, and place evenly for 5 minutes before use.
3. Material structure: wipe the adhesive on the back of EPS components with a trowel, and then evenly knead and paste the EPS decorative lines on the bottom wall, which should be horizontal and straight. The joints of components shall be compressed into no gaps, and 2m shall be used. The flatness of components shall be checked with a ruler, and there shall be no glue between components. Paste method: according to the size of the bonding surface, it can be divided into paste and point edge paste.
4. Construction conditions: the construction temperature is above+5 ℃, and the relative humidity is below 85%.
5. Drying time: surface drying: 2 hours/25 ℃. The drying time will vary with the ambient temperature and humidity.
6. Tool cleaning: all tools shall be cleaned with water immediately after use.
The technical requirements for adhesives of EPS decorative lines during construction are mainly divided into the above six aspects. When building it, we need to pay attention to the requirements of these six aspects to ensure that they can be implemented as required. This will also enable us to achieve good construction results.
@Disclaimer: The reprinted content is from the network. If you have any objection, please contact us in time, and the network will delete it.
